Roots
Tree roots in the sewer line
A sewer pipe leaks a little warm, moist air and water at any joint that isn't tight. Roots grow toward it, slip in as fine hairs, and thicken inside the pipe into a mat that catches paper.
Signs it's roots
- The main line slows gradually, clears after cleaning, then slows again months later.
- Gurgling from the toilet or tub when a lot of water drains at once.
- A cable that comes back with fibres or root pieces wound round the head.
- A large tree, or a stump from one, between the house and the street.
How roots are dealt with
- 1
Cut
A cable machine with a root cutting blade shears the roots back to the pipe wall.
- 2
Clean
Jetting clears the fine hairs and the debris the cutter leaves.
- 3
Look
A camera shows whether roots enter at one joint or many, and whether the pipe is cracked.
- 4
Decide
One bad joint can often be repaired in place. Roots at every joint usually mean the line is due for lining or replacement.
Roots under the right of way
The City of Killeen's program for sewer service lines in the public right of way lists root intrusion among the problems it covers. If the camera places the roots past your property, call 1-833-785-4547 and describe what was found (city page).
Before you cut down a tree
Removing the tree doesn't seal the pipe; dead roots rot in the joints and new ones from other trees find the same gap. Repairing the pipe is what stops the problem. If you do plant, keep new trees well away from the sewer route.